User manual
CIP-ALL
CIP-ALL
- Page 16
5.2.
Admin IP Address
Configuring the IP address from the ADMIN console interface
Connect a PC COM to the CIP-ALL ADMIN console port (on the right side of the product)
Start a terminal communication software (HyperTerminal, or Procomm for example), set for 19,200 bps, 8, N, 1.
The user login and password are
root
and
admin
on this console port
Enter the command
system-config-network
and answer questions.
If the choice in parentheses is correct, then just press the Enter key. If not, then enter the proper parameters.
=============================================================================
Welcome to the CIP-ALL SN=1110999991003
Enter 'h' to read help.
=============================================================================
CIP4ALL login:
[root@CIP4ALL /root]# system-config-network
**** Network configuration tool ****
configure lan
IP address (192.168.1.1) :
10.0.0.1
netmask (255.255.255.0) :
255.255.255.0
gateway (0.0.0.0) :
0.0.0.0
Set switch to factory settings (y/n) ?
========= Restart network ===========
Running sysctl
Interface eth0 : ip=10.0.0.1 netmask=255.255.255.0 gw=0.0.0.0
Setting up networking on eth0:
Setting nameserver to 10.0.0.1 in /etc/resolv.conf:
