CXR CIP-2ALL, User Manual

Page: 12 / 54

User manual CIP-ALL
CIP-ALL - Page 12
1. Introduction
The CIP-ALL emulates analog voice circuits over an Ethernet and IP network. It converts an asynchronous RS-232 interface to IP and has an
E1 option featuring Circuit Emulation Services over IP. It connects to the Ethernet network through a 10/100BT port, or an optical Gigabit
Ethernet port.
The voice and E1 interfaces are converted by TDM over packet processor according to the SAToP or CESoPSN standards.
A Bundle defines a set of parameters to transport a circuit between two CIP-ALL products.
Point-to-point, point-to-multipoint, and even protected optical ring topologies can be designed with the CIP-ALL.
A basic application requires two CIP-ALL units to interconnect all of the interfaces.
Each CIP-ALL provides:
•
4x Ethernet 10/100 Base TX.
•
2x Gigabit Ethernet optical interfaces.
•
1x asynchronous RS-232 / V.24 / V.28 port.
•
4 Analog interfaces: 2 or 4 wire (Leased Lines) or 2 wire FXO or FXS or 4 wires E&M.
The CIP-ALL is available with a 48 Vdc (36 -72 Vdc) or 12/24 Vdc (9-36 Vdc) power input, and a 110-230 Vac mains to 48 Vdc converter option.
1.1. Ethernet and Gigabit Ethernet interfaces
The CIP-ALL connects to other devices on the network through four 10/100 Base TX (RJ45) Ethernet ports, and two Gigabit optical ports.
The product embeds an Ethernet switch that delivers wire speed switching, QoS, VLAN functions.
1.2. Analog Interfaces
The CIP-ALL is connected with one or many other remote CIP-ALLs to transport 2 or 4 analog interfaces:

2 and 4 wire E&M and Leased Line emulation, 300 to 3400 Hz voice frequency signals to connect to leased line modems, RTU / SCADA /
Remote Control devices. Input level 0 dB max, or input level +3 dB max (option -108)

FXO interface to connect to a PBX with ringing and On Hook / Off Hook function detection.

FXS interface to connect to a telephone set or a dial-up modem with ringing and On Hook / Off Hook functions.

E&M interface to connect a PBX and a telco interface.
1.3. RS-232 Terminal Interface
An RS-232 serial asynchronous port is available on the CIP-ALL to connect a 300 to 115,200 bps asynchronous terminal. Asynchronous data
are converted to IP with UDP/TCP encapsulation and transported over the Ethernet/IP network.
The CIP-ALL features different protocols for asynchronous data control:
•
Raw-IP: transparent mode.
•
Modbus: Modbus and Gibus Industrial protocol emulation, and master / slave point to multipoint mode.
•
Message: bloc of data with a ending character.
•
Bloc: bloc of data followed by an idle / silence delay
The interface is addressed by an IP address and TCP / UDP port.
Other specific protocols may be available from CXR: please ask CXR for details.
1.4. Configuration
The CIP-ALL can be managed from the Ethernet network by http or https protocol, and a Web Browser.
IP
Network,
Ethernet…
CIP-2ALL-2O
CIP-2ALL-2S