18
GENERAL CUTTING
– cont’d
WARNING:
Do not force the circular
saw. Use only enough force to keep the
blade cutting at full speed. Excessive
pressure on the blade will cause it to slow
down and overheat, resulting in poor cut
quality and damage to the motor.
RIP GUIDE CUTTING
1.
Set the rip guide foot at the required width
(Fig. 9).
NOTE:
When starting the cut, make sure the
blade is parallel to the edge of the workpiece
and the rip guide foot is against the edge of the
workpiece.
2.
Proceed with the cut as outlined in
"
GENERAL CUTTING
"
above.
NOTE:
As you move the saw through the
workpiece, make sure the guide foot stays in
contact with the workpiece.
ASSEMBLY AND OPERATING
!
Summary of Contents for ConstruX
Page 20: ...20 EXPLODED VIEW...
Page 23: ......
