30
29
POTENTIAL FOR ELECTROMAGNETIC
INTERFERENCE
To avoid inaccurate results caused by electro-
magnetic interference between electrical and
electronic equipment, do not use the device near
a cell phone or microwave oven.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equip-
ment. Such modifications could void the user authority to oper-
ate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
TROUBLESHOOTING
If any abnormality arises during use, please check the following
points:
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble
or attempt to repair the unit by yourself. Contact informa-
tion for HoMedics Consumer Relations Department can be
found on the warranty page.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not
turn on when the
START/STOP
button is pushed.
Batteries have
run down.
Replace them
with two new AAA
alkaline batteries.
Battery polarities
have been posi-
tioned incorrectly.
Re-insert the
batteries in the
correct positions.
EE measurement
error symbol shown
on display or the
blood pressure
value is displayed
excessively low
(or high).
Cuff has been
placed incorrectly.
Wrap the cuff prop-
erly so that it is posi-
tioned correctly.
Did you talk or move
during
measurement?
Measure again.
Keep wrist
steady during
measurement.
Shaking of the wrist
with the cuff on.
E1 error symbol
shown on display
Air circuit
abnormality.
Measure again.
E2 error symbol
shown on display
Inflation pressure
exceeding 300 mmHg.
Switch the unit off,
then measure again.
E3 error symbol
shown on display
Error determining
measurement data.
Measure again.