Page 29
WARNING
Before disassembly, please empty any oil
from the motor’s crankcase in the case of
four-stroke engines.
WARNING
Once assembled, the carburettor’s fuel hose
must be verified to check there are no
leakages.
5.7 Safety components
ON/OFF SWITCH AND PICTURE
5.8 Calibration and settings
The machine does not need to undergo a process of calibration. The throttle
trigger’s travel setting must allow for the machine to achieve the maximum RPMs
announced by the manufacturer.
5.9 Storage
G
ENERAL RECOMMENDATION
Prior to storing the machine, it must be cleaned as per the instructions described
in the
On-site cleaning
section. Once clean, the mobile parts must be lubricated.
S
TORAGE CONDITIONS
While the machine is in storage, the following conditions must be maintained:
• Temperature: B2 °C and +40 °C (preferably, room temperature)
• Relative humidity: Between 0% and 95%, without condensation (preferably at
low humidity).
Once out of storage, clean the machine again and carry out a leakage test before
further use.
6 Problem resolution
Should a problem not included in the problem resolution table appear, please visit
the official technical service centre, the distributor or the manufacturer.
Summary of Contents for JC300
Page 2: ...Page 2...