Custom Audio Electronics PP54 EVO, User Manual

Page: 47 / 88

6.4 Communication parameters
The device allows the coniguration of the parameters listed in the following table.
The parameters marked with the symbol D are the default values.
Settings remain active even after the device has been turned of and they are stored in non-volatile memory.
RS232 BAUD RATE Communication speed of the serial interface:
9600 57600
D
19200 115200
38400
Parameter valid only with serial interface.
RS232 DATA LENGTH Number of bit used for characters encoding:
7 bits/car
8 bits/car
D
Parameter valid only with serial interface.
RS232 PARITY Bit for the parity control of the serial interface:
None
D
= parity bit omitted
Even = even value for parity bit
Odd = odd value for parity bit
Parameter valid only with serial interface.
RS232 HANDSHAKING Handshaking:
Xon/Xof = software handshaking
Hardware D = hardware handshaking (CTS/RTS)
Parameter valid only with serial interface.
When the receive bufer is full, if handshaking is set to XON/XOFF, the device sends
the XOFF (0x13) on the serial port. When the receive bufer has cleared once again, if
handshaking is set to XON/XOFF, the device sends the XON (0x11) on the serial port.
USB ADDRESS NUMBER
Numerical address code for the univocal identiication of the USB device (in case of more
than a USB device connected with the same PC):
0 D 2 4 6 8
1 3 5 7 9
USB MASS STORAGE Sharing mode from Mass Storage:
Disabled = sharing mode disabled
Enabled
D = sharing mode enabled
47