Custom Audio Electronics MODUS3, User Manual

Page: 39 / 76

5.6 Alignment parameters
This device allows the coniguration of the parameters listed in the following table.
The parameters marked with the symbol D are the default values.
Settings remain active even after the device has been turned off and they are stored in non-volatile memory.
BLACK MARK POSITION
Alignment management:
Disabled D = the black mark alignment is not performed
Enabled = the black mark alignment is performed
BLACK MARK THRESHOLD
Threshold value (in percent) for the recognition of the presence of black mark by the
black mark sensor:
30% 70%
40% 80%
50%
D 90%
60%
If “Black Mark Position” parameter is set on "Disabled", this parameter has not effect on
device coniguration and it is not printed on setup report.
BLACK MARK DISTANCE
“Black Mark Distance” is the minimum distance (in millimeters) between the upper edge
of ticket and the black mark (see
chapter 6 ).
If “Black Mark Position” parameter is set on "Disabled", the parameters for the “Black
Mark Distance” are not printed.
The numeric value of the distance is made up with the following four parameters for the
setting of three digits (two for the integer part of the number, one for the decimal part
and of the sign):
BLACK MARK DISTANCE
SIGN Sign setting:
+ D = positive distance
- = negative distance
BLACK MARK DISTANCE
[mm x 10] Setting the digit for tens:
0 D 2 4 6 8
1 3 5 7 9
BLACK MARK DISTANCE
[mm x 1] Setting the digit for units:
0 D 2 4 6 8
1 3 5 7 9
BLACK MARK DISTANCE
[mm x .1] Setting the digit for decimals:
0 D 2 4 6 8
1 3 5 7 9
39