Custom Audio Electronics KPM202, User Manual, Page: 113 / 116

13.5 Setup
It is possible to conigure the default parameters for device and network setup by editing the “Setup.ini” ile on the device
lash drive. You can enter the lash drive by iles sharing from Mass Storage. In this case, the relative parameter should be
enabled during the coniguration process (see chapter 6).
The “Setup.ini” ile is a coniguration ile that contains all the conigurable parameters listed in text format and divided into
some sections (indicated in square brackets).
The available values for every parameter, are listed after the parameter name. The value marked with the symbol ‘ * ’ is
the default one.
To modify device’s parameters, change the numeric value after the name of parameters. To set the parameter to the default
value, change the numeric value with the symbol D.
After editing device’s parameter, simply save the “Setup.ini” ile to make the modiies activated.
The “Setup.ini” ile permits the coniguration of the following parameters:
[PRINT]
Printer Emulation 0, 1* 0 = CUSTOM/POS
1 = SVELTA
Print Mode 0*, 1 0 = Normal
1 = Reverse
Autofeed 0*, 1 0 = CR disabled
1 = CR enable
Chars / inch
KPM202,
TK202 0, 1* 0 = A=11 B=15 cpi
1 = A=15 B=20 cpi
KPM203,
TK203 0, 1* 0 = A=16 B=23 cpi
1 = A=23 B=30 cpi
Speed / Quality 0, 1, 2* 0 = High Quality
1 = Normal
2 = High Speed
Paper Width 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10,
11, 12, 13, 14*, 15, 16, 17,
18, 19, 20, 21, 22, 23, 24, 25,
26, 27, 28, 29, 30 0 = 54 mm
1 = 56 mm
2 = 58 mm
3 = 60 mm
4 = 62 mm
5 = 64 mm
6 = 66 mm
7 = 68 mm
8 = 70 mm
9 = 72 mm
10 = 74 mm 11 = 76 mm
12 = 78 mm
13 = 80 mm
14 = 82 mm
15 = 20mm
16 = 22 mm
17 = 24 mm
18 = 26 mm
19 = 28 mm
20 = 30 mm
21 = 32 mm 22 = 34 mm
23 = 36 mm
24 = 38 mm
25 = 40 mm
26 = 42 mm
27 = 44 mm
28 = 46 mm
29 = 48 mm
30 = 50 mm
31 = 52 mm
113