Custom Audio Electronics KPM180H, User Manual

Page: 78 / 152

6.7 Operation parameters
The parameters marked with the symbol D are the default values.
Settings remain active even after the device has been turned of and they are stored in non-volatile memory.
PRINTER EMULATION
Available emulations for the device.
SVELTA
CUSTOM POS
D
PRINT MODE
Printing mode.
Normal D = enables printing in normal writing way
Reverse = enables printing rotated 180 degrees
AUTOFEED
Setting of the Carriage Return character:
CR disabled D = Carriage Return disabled
CR enabled = Carriage Return enabled
The parameter is printed on setup report only if the parameter "Printer emulation" is set
on "CUSTOM POS".
CODE TABLE
Identiier number of the character code table to use.
See paragraph 9.11
to learn about the character tables corresponding to the identiication
numbers set with this parameter.
The character tables set with this parameter are the same set with the command 0x1B
0x74 (refer to the commands manual of the device).
The numeric value of the identiier is made up with the following two parameters for the
setting of two digits for the tens and the units:
CODE TABLE [num x 10]
Setting the digit for tens:
0 D 2 4
1 3 5
CODE TABLE [num x 1]
Setting the digit for units:
0 D 2 4 6 8
1 3 5 7 9
CHINESE FONT Setting of the Chinese font:
Disabled D = Disables the use of the Chinese extended font GB18030-2000
Enabled = Enables the use of the Chinese extended font GB18030-2000
When the Chinese font is enabled, the selection of the character code table is suspended
(parameter “Code table”). When the Chinese fonts is disabled, it returns the character
code table previously in use (parameter “Code table”).
78