Cushman TURF-TRUCKSTER, Service & Repair Manual, Page: 103 / 263

DIFFERENTIAL ASSEMBLY REMOVAL
1. Remove the brakes, wheel hubs, axles and axle
tubes as described in the preceding paragraphs.
2. Remove the axle tubes as described in the pre-
ceding paragraphs.
3. Remove the brake tubes, brake hose, clamp, tee
and bracket from the differential housing as
shown in Figure 4I-5.
4. Disconnect the differential control cable from the
shift shaft and cable bracket.
5. Remove the drain plug and drain oil from the dif-
ferential in accordance with environmental regula-
tions. Re-install and tighten the drain plug.
6. Disconnect the drive shaft yoke nut and special
washer from the differential input shaft as shown
in Figures 4C-1 and 4C-2.
7. Remove the jack stands from under the axle.
Guide and carefully lower the differential until the
drive shaft separates from the input shaft.
Remove the differential assembly from under the
chassis.
8. Clean the exterior of the differential before pro-
ceeding with further disassembly and repairs.
Move the differential to a suitable work bench or
table.
DRIVE TRAIN
SECTION 4I. REAR AXLE
4I-5
4I
Figure 4I-5. Differential Removal