Cushman Hauler 4x4 Crew Diesel 2019, Operator'S Manual

Page: 58 / 72

56
8. Start at the rear of the cargo box and
tuck the outer side panel under the
cargo box and work it into place from
back to front.
MOD111
9. Once the outer side panel is in place,
install the screws securing the cargo
box fender and outer side panel.
MOD114A
MOD115A
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The geometric center of the HIGH beam
light zone is to be used for aiming.
1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).
MOD626

NOTE: There should be an aver-
age operating load on the vehicle
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface directly in front of the
headlights.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical mark
5 cm (2 in.) below the horizontal
mark on the aiming surface.
7. With a 10 mm wrench, turn the head-
light adjuster clockwise to adjust the
beam down or counterclockwise to
adjust the beam up.
MOD046A