Curtiss-Wright | PG Drives Technology
SK77981-14
79 | R-net Technical Manual | Chapter 3 – Programming
7.4
SPEED ADJUST - (SPEED ADJUST)
This sets whether the Speed Down and Speed Up buttons on the Joystick Module are active.
The programmable options are Yes and No.
7.5
PROFILE BUTTON
This sets whether the Profile button on the JSM will select just Profiles, or Profiles and Modes .
The programmable options are Profiles and Profiles/Modes.
If set to Profiles, then the Profile button will select just the available Profiles.
If set to Profiles/Modes, then the Profile button on the JSM will select the available Profiles, then the available Modes. i. e. the
operation is identical to a button connected into the External Profile Switch Jack.
7.6
ACTUATOR ENDSTOP BEEP - (ENDSTOP BEEP)
This sets whether a short beep occurs when an actuator mechanism reaches an end position.
The programmable options are Yes and No.
NOTE:
The beep will only occur on actuator mechanisms that use automatic endstop detection, i.e. over -current measurement.
7.7
SOUNDER VOLUME - (SOUNDER VOLUME)
This sets the volume of the audible feedback given whenever a button or switch on the Joystick Module is operated.
The programmable range is 0 to 10 in steps of 1.
If set to 0, there will be no sound given. Higher values will give progressively louder sounds.
7.8
LOCK FUNCTION EN ABLED – (LOCK FN ENA BLE)
This sets if and how the R-net may be locked to prevent the wheelchair being used by unauthorised persons.
The programmable options are as follows:
None
Means the R-net cannot be locked
Seq
Means the keypad locking sequence can lock/unlock the R-net.
(Refer to Chapter 1 – Operation for sequence details).
Key
Means a Curtiss-Wright supplied key can lock/unlock the R-net.
Both
Means either the keypad or a key can be used to lock/unlock the R-net.
7.9
REVERSE DRIVING ALARM - (REV DRIVING ALARM)
This sets whether a warning alarm is sounded while the wheelchair is driving in reverse.
The programmable options are Yes and No.
