MNL-0641-01 Rev A3
ECO-4823
Effective: 04 Oct 16
Page 81 of 107
startup-config Startup configuration
SWI2210-XXXX# copy
Clear Commands
Clear commands clear (reset) specified settings to factory defaults.
SWI2210-XXXX# clear ?
access Access management
access-list Access list
dot1x IEEE Standard for port-based Network Access Control
eps Ethernet Protection Switching.
erps Ethernet Ring Protection Switching
evc Ethernet Virtual Connections
ip Interface Internet Protocol config commands
ipv6 IPv6 configuration commands
lacp Clear LACP statistics
link-oam Clear Link OAM statistics
lldp Clears LLDP statistics.
logging Syslog
mac MAC Address Table
mep Maintenance Entity Point
mvr Multicast VLAN Registration configuration
network-clock Clear active WTR timer.
sflow Statistics flow.
spanning-tree STP Bridge
statistics Clear statistics for one or more given interfaces
SWI2210-XXXX# clear
Modes
Example: VLAN Configuration Mode Commands
SWI2210-XXXX(config)# vlan 100
SWI2210-XXXX(config-vlan)# ?
do To run exec commands in config mode
end Go back to EXEC mode
exit Exit from current mode
help Description of the interactive help system
name ASCII name of the VLAN
no
SWI2210-XXXX(config-vlan)#
Example: Interface Configuration Mode Commands
SWI2210-XXXX(config)# interface GigabitEthernet 1/10
SWI2210-XXXX(config-if)# ?
access-list Access list
aggregation Create an aggregation
do To run exec commands in config mode
dot1x IEEE Standard for port-based Network Access Control
duplex Interface duplex
end Go back to EXEC mode
evc Ethernet Virtual Connections
excessive-restart Restart backoff algorithm after 16 collisions (No
excessive-restart means discard frame after 16
collisions)
exit Exit from current mode
flowcontrol Traffic flow control.
green-ethernet Green ethernet (Power reduction)
gvrp Enable GVRP on port(s)
help Description of the interactive help system
ip Internet Protocol
ipv6 IPv6 configuration commands
lacp Enable LACP on this interface
link-oam Enable or Disable(when the no keyword is entered) Link
OAM on the interface
lldp LLDP configurations.
loop-protect Loop protection configuration on port
mac MAC keyword
media-type Media type.
mtu Maximum transmission unit
mvr Multicast VLAN Registration configuration
network-clock network-clock
no Negate a command or set its defaults
poe Power Over Ethernet.
port-security Enable/disable port security per interface.