Curtiss-Wright FHB5-PE1MWB04-00, User Manual, Page: 33 / 72

INSTALLATION
5-3
FibreXtreme User Guide Copyright 2017
5.1 Overview
SL240 PCIe cards require only one slot on the host computer backplane and interface directly to
a fiber-optic cable.
To install an SL240 PCIe card, follow the steps below:
1. Unpack the card.
2. Inspect the card.
3. Install the card.
4. Connect the cables.
5.2 Unpack the Cards
CAUTION : Exercise care regarding the static environment. Use an anti-static mat
connected to a wristband when handling or installing the SL240 PCIe card. Failure to do
this may cause permanent damage to the components on the card.
Follow the steps below to unpack the card:
1. Put on the wristband attached to an anti-static mat.
2. Remove the card and anti-static bag from the carton.
3. Place the bag on the anti-static mat.
4. Open the anti-static bag and remove the card.
5. In the unlikely event that you should need to return your SL240 PCIe card, please
keep the original shipping materials for this purpose.
Any optional equipment is shipped in separate cartons.
5.3 Inspect the Cards
The SL240 PCIe card consists of a single card with a built-in link interface. If the card was
damaged in shipping, notify Curtiss-Wright, or your supplier immediately.
5.4 Install the SL240 PCIe Card
WARNING : Turn off all power to your operating system before attempting to install the
SL240 PCIe Card.