TROUBLESHOOTING GUIDE
TG6
G4 BREWERS WITH TRIAC, TROUBLESHOOTING GUIDE
080416NC
Water Does Not Heat At All
• Check to see if the water level in the tank is in contact with the water level probe. If not, see
Tank Does Not Fill
.
The water will not heat unless it is in contact with the probe.
• If the water heats, but is not hot enough, see
Water Not Hot Enough
.
• If
Ready to brew
appears on the display, but the water is not hot, check the resistance across the leads of the
temperature sensor. If the resistance is less than 10 k and the water is not hot, replace the temperature sensor.
If the temperature sensor resistance is above 10 k when the water is cool, replace the universal power module
(UPM).
If
Heating...
appears on the display, but the water is not hot, follow the steps below. The following steps are
performed with the rear toggle switch in the ON position.
1 Check for power across the terminals of the heating element(s). If power is being supplied, remove the wires
and check for an open heating element.
2 If there is no power to the element(s), trace the circuit back (using the ELECTRICAL SCHEMATIC) to the power
DPSEUPmOEPVUXIFSFQPXFSJTMPTU*GUIFSFJTQPXFSJOUPUIFUSJBDCVUOPUPVUTFFUIFGPMMPXJOHTUFQ
3 If there is power into a triac, but not out, check for power at the gate terminal. Also check the wire to A2 from
the UPM. If the connections are good and power is being supplied to the triac, but there is no voltage out
of A2, replace the triac. If power is not being supplied from the UPM, but
Heating...
appears on the display,
check the wiring from the UPM to the triac. If the wiring is OK, replace the UPM.
Over Temp Sensor Error Message
This error message indicates that the universal control module (UCM) has detected a water overheating
problem. The universal power module (UPM) is reading a water temperature in the tank above 210ºF. If the water
temperature is too hot, but
Heating...
appears on the display, see
Water Too Hot
. Once the malfunction causing
the error is corrected, the error message must be cleared. To reset the brewer and return to normal operation, turn
the toggle switch on the back of the brewer to the OFF position for 5 seconds, then back on.
1 Check for power at the gate terminal on the triac. If there is no power at the triac gate terminal but the heating
elements are always on, replace the triac.
2 Turn off power to the brewer and allow water tank to cool. Once cool, turn power back on while monitoring the
triac gate voltage. During normal operation, power should be applied to the gate terminal, then drop to below
1 Vac. The universal power module (UPM) should be replaced if power is applied to the triac gate constantly
even though
Ready to brew
or
Over Temp Sensor
appears on the display.
3 If the UPM is operating normally, check for a false over-temp error caused by the temperature sensor. Check
the resistance across the leads of the temperature sensor. If the resistance is less than 10 k when the water is
cool, replace the temperature sensor.
