Curtis PCGT4 Service Manual Download

Page: 1 / 8

3. Plug the power cord into an electrical outlet rated at 20A.
4. Turn on power at the toggle switch behind the unit. The lights (display window and row of but-

tons) on the front door will activate and the heating tank will start to fill.

5. Water in the heating tank will require about one hour to reach operating temperature (factory

setting of 190°F). At this time the LCD will display “READY TO DISPENSE”.

6. Remove and fill the canisters with powdered cappuccino product.

Your Curtis G3 System is Factory Pre-Set and Ready to Go, Right from the Box.

Following are the Factory Settings for your Primo Cappuccino Beverage System:

• Tank Temperature = 190°F

• Flavor Controls= Set at 60%

• Dispensing Mode Set for Manual Dispensing

Generally there will never be a reason to change your G3 programming. However, should you need

to make slight adjustments to meet your dispensing needs, programming instructions are provided

later in this manual.

System Requirements:

• Water Source 20 – 90 PSI (Minimum Flow Rate of 1 GPM)

• Electrical: See electrical schematic on page 7.

Models Included

• PCGT4
• PCGT5

CAUTION: DO NOT

connect the unit to hot

water. The inlet valve is

not rated for hot water.

CAUTION: Follow this

setup procedure before

attempting to use this

unit. Failure to follow these instruc-

tions can result in injury and/or void

of warranty.

CAUTION: Equipment

must be installed to

comply with applicable

federal, state, and local plumbing/

electrical codes having jurisdiction.

Important Safeguards/Symbols

This appliance is designed for commercial use. Any servicing other than cleaning and routine main-

tenance should be performed by an authorized Wilbur Curtis Co., Inc. service technician.

• DO NOT immerse the unit in water or any other liquid

• To reduce the risk of fire or electric shock, DO NOT open service panels. There are no user

serviceable parts inside.

• Keep hands and other items away from hot areas of the unit during operation.

• Never clean with scouring powders or harsh chemicals.

ilbur

urtis

., i

Service Manual – PCGT4 & PCGT5

Symbols

WARNINGS – To help avoid personal injury

Important Notes/Cautions – from the factory

Sanitation Requirements

NSF International requires the following water connection:

1. A quick disconnect or additional coiled tubing (at least 2x the depth of the unit) so that the machine

can be moved for cleaning underneath.

2. This equipment is to be installed with adequate backflow protection to comply with applicable

federal, state and local codes..

3. Water pipe connections and fixtures directly connected to a potable water supply shall be sized,

installed and maintained in accordance with federal, state, and local codes.

SETUP STEPS

1. The unit should be level (left to right - front to back), on a secure surface.
2. Connect the water line to the water inlet fitting on the rear of the unit. Water volume going to the

machine should be consistent. Use tubing sized sufficiently to provide a minimum flow rate of

one gallon per minute.

NOTE: A water filtration system must be used to help maintain trouble-free operation.

Air must

be purged from the cartridge prior to connection to equipment.

In areas with extremely

hard water, we highly recommend the use of a Curtis approved water filter. For our full line of

filters, please log on to www.wilburcurtis.com.

ISO 9001:2008 REGISTERED

WILBUR CURTIS CO., INC.

6913 Acco Street,

Montebello, CA 90640-5403