10
EXPERT WW rev.12
EXPERT WW
Program Settings
Use to navigate
Program 2 above day:
10
Program 3 above day:
20
Program 2 above Out T:
50.0
Program 3 above Out T:
75.0
Show Settings : Program 1
[ or ]
Running Prog.:
Program 1
2. Set the following parameters:
Program #x above —
If the program switch
is based on the animal age, select the day at
which programs 2 and 3 start; if the switch
is based on the outside temperature, select
the outside temperature above which each
program starts. Note that program 1 is au-
tomatically used when the animal age (or
outside temperature) is lower than the value
defined for programs 2 and 3.
Show settings of —
Even when a program is
running you can still display parameter set-
tings of other programs without changing the
program in use. Select the desired program
to be displayed on screen. *
Only the programs
that are enabled in the Installation Setup are avail-
able (see sec. 4.5).
Running program —
This message is shown
when the program selection is made manually
(i.e., it is not selected as a function of the day
and/or outside temperature). Select the run-
ning program. *
Only programs that are enabled
in the Installation Setup are available (see sec. 4.5).
The day number refers to the animal age.
4.3.2. Copying & Pasting Programs
Use the copy-paste function to duplicate all
parameter settings associated to a program
onto another program. This avoids repeating the
same programming sequence several times.
1. Select:
Main menu
Setup *
Copy/Paste
* A password may be required to access this menu.
Program Settings
Copy From:
Program 1
Copy to:
Program 2
Confirm?
No
2. Set the following parameters:
Copy From —
Select the source program. The
one that will be duplicated.
Copy to —
Select the target program. The
one on which the copied program will be
pasted.
3. Once a different source and target
programs are selected, the message “Con-
firm?” is displayed. Select
“Yes”
to start the
program duplication. The message “ Copy
in progress” is displayed. Wait until the data
transfer is over.
4.4. Measuring Units
1. Select:
Main menu
Setup *
User
Units
* A password may be required to access this menu.
Unit Selection
Time Display
AM/PM
Temperature
Deg F
Water
Liter
Static Pressure
“WC
2. Select the proper measuring units:
Time display —
AM/PM / 24 hours;
Temperature units —
Celsius (Deg C) or
Fahrenheit (Deg F).
Water —
Gallons / Liters
Static Pressure —
Inches of water (“WC) or
Pascal (Pa).
Measuring units are common to all pro-
grams of the controller.
