Cumberland EDGE 890-00601, Installation And User Manual

Page: 28 / 258

Chapter 2: Basic connections
4. Install the cable connectors or rigid conduit adaptors to the bottom of each enclosure.
5. Close the enclosures and lock the latch.
IMPORTANT: Leave the rated clearance to allow the cover to be removed for maintenance
Remember
Do not mount the enclosures directly onto the drywall. If the supporting structure behind the drywall
cannot support the enclosures, solidify it by adding a wooden or metal frame.
Mounting the enclosures
Securely mounting the enclosures to the wall in the ideal location allows for an optimal use of the system
when navigating the menus.
Before You Begin
NOTICE
When using outdoor connections, mount the enclosure as close as possible to the
entry point of the wiring
IMPORTANT: The enclosures must be mounted near an AC Power with a disconnecting switch
IMPORTANT: Mount the system into a wooden or metal frame. Do not mount the system directly into the
drywall
NOTE: Install the enclosures (EDGE Main Controller, 3-Slot Expansion Box, 6-Slot Expansion Box) with
the hinges on the left hand side when facing the enclosure.
NOTE: AP/Cumberland recommends this kind of screw: Flange Head Lag Screw for Wood, Hot-Dipped
Galvanized Steel, 1/4" Diameter, 2" Long.
1. Place the enclosure at a height at which you can properly see the screen.
2. Verify that all enclosures open easily.
IMPORTANT: Leave a clearance as stated in Clearance around the system to allow the cover to
be removed for maintenance.
CAUTION
To avoid injury, ask for help to install the enclosures.
Installing the plug-in modules
When you buy a complete Expansion Box, the plug-in modules that come with it are already installed in
the Expansion Box . When you buy a new plug-in module and you are ready to start using it, you must
install it in the Expansion Box correctly to ensure proper operation.
What You Should Know
28 895-00693 EDGE