Culligan Aquasential Smart HE 9" Cullar, 10" Cullar, 9" Cullar Outdoor,
10" Cullar Outdoor Water Filter
Culligan knows the more informed you are about your water treatment systems, the more confident you will be about its performance� It’s because
of this and more than seventy years of commitment to customer satisfaction that Culligan is providing this Performance Data Sheet to its customers�
NOTE!
Read this Performance Data Sheet and compare the capabilities of this unit with your actual water treatment needs.
It is recommended that before purchasing a water treatment unit, you have your water supply tested to determine
your actual water treatment needs.
Manufacturer:
Culligan International Company
9399 W� Higgins Rd�, Suite 1100
Rosemont, IL 60018 USA
(847)
430-2800
Product: Culligan Aquasential Smart High Efficiency 9" Cullar, 10" Cullar, 9" Cullar Outdoor, and 10" Cullar Outdoor Water Filter
Testing Conditions & Results:
Capacity:
120,000 gallons for 9" filters
Pressure:
60 psi
180,000 gallons for 10" filters
Temperature: 63 - 73° F (17 - 23° C)
Service Flow Rate: 4�0 gpm @ 2�0 psi for 9" filters
pH:
7�6
5�9 gpm @ 5�0 psi for 10" filters
Operating Conditions:
Operating Temp� Range: 33 - 120°F (1 - 50°C)
Water Press� Range:
20 - 125 psi (140 - 862 kPa)
Electrical Characteristics: 24 VDC, 21�6 Watts
Water Press� Range (Canada):
20 - 90 psi (140 - 620 kPa)
Substance Reduction
While testing was performed under standard laboratory conditions, actual performance may vary�
Name of Substance
Influent Challenge Concentration
Reduction Requirement
Chlorine
2�0 mg/L ± 10%
≥ 50%
The Culligan Aquasential Smart High Efficiency Cullar filters have been tested and certified by WQA
against NSF/ANSI Standard 372, CSA B483�1, and NSF/ANSI Standard 42 for the effective reduction
of chlorine taste and odor up to 120,000 gallons for the 9" filter and 180,000 gallons for the 10" filter, as
verified and substantiated by test data� The concentration of the indicated substances in water entering
the system was reduced to a concentration less than or equal to the permissible limit for water leaving
the system, as specified in NSF/ANSI 42�
Performance Indicator:
If water flow decreases or a noticeable taste change occurs, a reconditioning cycle should be initiated� If conditions do
not improve, contact your local Culligan dealer� They can determine if your filter requires servicing� Do not use with water that is microbiologically
unsafe or of unknown quality without adequate disinfection before or after the system� Refer to the Specifications, Familiarization and Warranty
section of this Owner’s Guide (P/N 01040707) for more specific product information� To avoid contamination from improper handling and
installation, your system should only be installed and serviced by your Culligan dealer� Performance will vary based on local water conditions�
The substances reduced by this system are not necessarily in your water�
Buyer Signature _______________________________________________________________________ Date ____________________
Seller Signature _______________________________________________________________________ Date ____________________
21
01040707 B 07/21
Performance Data Sheets
