Culina UBTCC75, User Manual, Page: 26 / 28

26
o
Replace the cable with one of the same length and in accordance with
the specification given on page 21.
o
The “green-yellow” earth wire must be connected to the terminal
marked . It must be about 10 mm longer than the live and neutral
wires.
o
The “blue” neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).
o
The cooking zones are not functioning or will not switch on.
*
It has been more than 1 minute since the appliance was switched on.
You should switch the appliance back on again, using the ON/OFF
button and then switch on a cooking zone.
*
Several cooking zone selection buttons have been pressed at once. You
should only try to switch on one cooking zone at once.
*
The safety cut out has been triggered. Press the ON/OFF button to
reset the hob.
*
Check that the mains electrical supply to the appliance is correct and
working. Check the mains fuse.
o
The residual heat indicator has not come on after I have
switched a cooking zone off.
*
The cooking zone has only been turned on for less than 30 seconds.
*
IMPORTANT: If the cooking zone does appear to be hotter than 60°C
or has been activated for longer than 30 seconds, and the residual
heat indicator has not come on, you should call the Customer Care
Department.
o
A humming sound is heard when a cooking zone is selected.
*
This is normal; the sound will disappear when the zone heats up.
o
The cooking zones have become discoloured.
*
This maybe caused by burnt on remnants of food. This will not affect
My appliance isn’t working correctly