Culina UBTCC75, User Manual, Page: 25 / 28

25
o
The cable connections must be in accordance with the diagram
located on the bottom of the hob (see above). The links must also be
positioned as indicated.
o
You should use a good quality screwdriver to carefully, fully tighten
ALL of the terminal screws.
o
If when the hob is first switched on, only two of the zones
work, you should recheck that the terminal screws are all fully
tightened and the links are in position. This should be done
before contacting the Customer Care Department.
o
The cable can be looped if necessary, but make sure that is not
kinked or trapped when the hob is in position. Care must be taken to
avoid the cable being in contact with hot parts of the appliance.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement.
The mains supply cable should be replaced in accordance with the
instructions on the next page:
o
Switch the appliance off at the socket.
o
Open the terminal block on the underside of the hob.
o
Unscrew the terminal screws fixing the cable.