CUBO CB1-0-01, Instruction Manual

Page: 18 / 24

12
▪ Obstructed way
If during crushing, the sensor detects an obstruction, the same error screen will be displayed,
and the same procedure will apply.
▪ Jammed CUBOPOD
When the CUBOPOD is crushed, it falls into the podbin. If it does not occur as expected,
a jammed CUBOPOD error message will be displayed:
If this happens, open the lid and manually push the empty CUBOPOD.
If any part of the frozen CUBOPOD is still stuck, remove it manually, make sure the frozen CUBOPOD is
pushed into the blender chamber, and the empty CUBOPOD falls into the podbin.
Close the lid and preparation will continue as normal.
If the empty CUBOPOD has not fallen into the podbin, the machine will ask you for confirmation of removal
before continuing the process. Note: Never continue process if the CUBOPOD is still jammed as it could
irreversibly damage the machine.
▪ No water flowing
If the water flow falls unexpectedly, the process will be halted, and the following error screen will be displayed:
In this case, it is mandatory to remove and place back the water tank to restart the cycle.
Check to see if the floating water level sensor isn’t jammed as this could be the cause of the problem.
Be sure there is sufficient water in the water tank.
3. Preparation error
▪ No water flowing
Interrupted operation
4. Power-on exception
If the machine is powered off while preparing a drink, a warning screen will be
displayed when powered on.
Wait for the machine to clean itself before inserting a new CUBOPOD.