CUBE
D
E
S
I
G
N
Cube Design A/S
Vadstedvej 212 | DK-8450 Hammel | Tlf./Phone no.: +45 86 98 74 11 | www.cube-design.dk/en | [email protected]
Step 7:
Mount the feet and adjustable shoes. The new feet have two holes where the feet are mounted with
2 x M8x25
bolts each. Then the adjustable shoes are screwed into the outer holes.
NOTE:
The old model feet are mounted with 4 x M6x25 bolts. These feet have a cross where the bolts go through.
The frame is now assembled and must be mounted on the plates. Use the
pre-drilled holes and the guiding lines as described below.
Step 8:
Start by fastening the slide rail with two screws into the two pre-drilled holes in the right side of the small
plate.
Step 9:
Adjust the frame according to the guiding lines in left side of the small
plate and secure it with two screws.