51
LUBRICATION TABLE
Point of
Lubrication
Check
at
Hours
Change
at
Hours
Capacity
Anticipated Air Temperature
Above +32°F
0°F and Above
32°F or Below
Engine crankcase
Check
before
each
use
100
Approx.
4 pints
Cub Cadet
Engine Oil
SAE 10W30
Cub Cadet
Engine Oil
SAE 10W30
Cub Cadet
Engine Oil
SAE 5W20
SAE 5W30
Hydro drive unit and
transmission case
with filter
Check
before
each
use
Add as
needed
Approx.
6 qts
Cub Cadet Drive System Fluid Plus
NOTE: Cub Cadet Drive System Fluid Plus is specially
formulated for this application. If any other oil is used
Cub Cadet will not be responsible for substandard
performance. Failures due to use of improper fluid
are not covered by warranty. For maximum protec-
tion, use Cub Cadet Drive System Fluid.Plus
Steering knuckles
and front axle
pivot bolt
10
Use 251H EP grease or equivalent No. 2 multi-
purpose lithium grease and apply two strokes
(minimum) or sufficient grease to flush out old
grease and dirt.
Front wheel
bearings
30
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Steering arm
housing
30
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Deck spindles
10
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Spindle belt
idler arm
10
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Deck Double Pulley
50
Use 251H EP grease or equivalent No. 2 multi-purpose
lithum grease. Do not over lubricate.
Deck front gauge
wheels
50
Use 251H EP grease or equivalent No. 2 multi-purpose
lithum grease.
Foot and lift con-
trol pivot points
10
Use a liberal amount of high grade lubricating oil.
Summary of Contents for LT 2138
Page 56: ...56...
