17
timeout (1-99) secs]
[-t timeout (1-
99)secs]
(optional)
[-r repeat (1-99)
times]
Enter the repeat value that how many times
should be pinged.
[-t timeout (1-99)
secs]
Enter the timeout value when the specified IP
address is not reachable. (optional)
Example
Gateway> ping 8.8.8.8
Gateway> ping 8.8.8.8
–s 128 –t 10
2.4.4 Reload Command
1. To restart the Gateway.
Command / Example
Gateway# reload
2. To specify the image for the next restart before restarting.
Command / Example
Gateway# reload Image-2
OK!
Gateway# reload
2.4.5 Write Command
To save running configurations to startup configurations, enter the write command. All unsaved
configurations will be lost when you restart the Gateway.
Command / Example
Gateway# write
Save Config Succeeded!
2.4.6 Configure Command
The only place where you can enter Global Configuration mode is in Privileged mode. You can
type in
“configure” or “config” for short to enter Global Configuration mode. The display prompt will
change from
“Gateway#” to “Gateway(config)#” once you successfully enter Global Configuration
mode.
Command / Example
Gateway#config
Gateway(config)#
Gateway#configure
Gateway(config)#
2.4.7 Show Command
The
“show” command is very important for network administrators to get information about the
device, receive outputs to verify a command
’s configurations or troubleshoot a network
