34
MCT-RACK(config)# user radius
Enable RADIUS authentication.
MCT-RACK(config)# user radius radius-
port 1812
Set RADIUS server port number to 1812.
MCT-RACK(config)# user radius retry-
time 2
Set the retry value to 2. The CHASSIS will try
to reconnect twice if the RADIUS server is
not reachable.
MCT-RACK(config)# user radius secret
abcxyzabc
Set up a secret for validating
communications between RADIUS clients.
MCT-RACK(config)# user radius server1
192.180.3.1
Set the primary RADIUS server address to
192.180.3.1.
MCT-RACK(config)# user radius server2
192.180.3.2
Set the secondary RADIUS server address
to 192.180.3.2.
2.6.12 Slot Command
This section is intended to introduce the configuration of specified media converters.
Note:
Make sure that media converts are firmly installed and power on.
1. Specify any slots to configure
Slot command
Parameter
Description
MCT-RACK(config)# slot
[slot_list]
[slot_list]
Specify any slots you want to configure.
2. Upgrade media converter firmware.
Slot command
Parameter
Description
MCT-RACK(config-slot-
slot-slot)# firmware
upgrade
Upgrade firmware.
Note:
Upgrade one media converter at a
time.
3. Configure link alarm
When UTP or fiber port is down during operation, the other port will be automatically turned
off to alert the user.
Slot command
Parameter
Description
MCT-RACK(config-slot-
slot-slot)# module link-
alarm
Enable link alarm function.
No Command
MCT-RACK(config-slot-slot-slot)# no
module link-alarm
Disable link alarm function.
Show Command