PRATIKA
User and Maintenance Guide Page 15/33
6 .
H A N D L I N G A N D T R A N S P O R T
Before moving the machine, check that the machine is stable (when the machine is at
rest, the braking mechanism blocking the machine located on the front wheels should be
activated. Also check the degree of incline of the surface where it is positioned).
Before moving the machine, remove the components that were installed after the
machine was delivered to avoid possible damage (See section on Installation).
During this phase we recommend:
- correctly storing all accessories to avoid breakage from accidental falling or other
damage during transport.
- transport at low speed and watching out for possible points that may cause instability.
- keeping at a safe distance.
Particular caution should be used when moving the machine in the work place. Avoid
areas where there are steps, tight corners or other obstacles. Incorrect transport could
compromise the exact calibration of the settings.
Fig.6
Fig.7
The operator transporting the machine can use
the wheels on the front of the machine base to
push it by hand.
The operator, to lift the machine at a distance,
should use a fork lift suitable to take the
machine weight (see the section on technical
characteristics) inserting the forks as illustrated
in the figure above,
