2
Aerial work platform
ZED 20.3 HV
COD. UM0284_GB | REV. 0.0 | ED: 09/17
GB
Chapter 11
SUPPORT AND WARRANTY
11.3
Warranty
OBliGATOrY
For the warranty conditions please refer to the warranty certiicate delivered
with the machine.
The machine is covered by warranty starting from the date it is delivered to the customer. For the
warranty terms and conditions, please refer to the warranty certiicate delivered with the machine.
The manufacturer reserves the right to repair or replace any parts considered to be defective within
the period of the warranty.
The warranty expires whenever the requirements and instructions of use indicated in this manual
are not observed. Work carried out under warranty is carried out during normal working hours at the
authorised workshops or at the manufacturer’s premises. Technicians’ travel costs are debited for
work carried out at the customer’s premises. The customer is billed for transport costs for work carried
out at the manufacturer’s premises.
During the replacement of defective parts, the manufacturer company cannot be held responsible
for any expenses sustained by the commercial agent and customer, any supposed present or future
damage, loss of earnings, forfeits, etc.
The warranty does not cover the replacement and/or repairs of parts that are worn out or damaged
during ordinary use of the machine.
11.3.1
Maintenance logbook transfer
The inspection logbook issued by CTE to the platform owner (pursuant to the meaning of Annex I to
Directive 2006/42/EC) is to be considered an integral part of the machine and must accompany the
machine throughout its operational life until it is scrapped.
The following information regarding the machine must be recorded in the logbook:
•
Change of ownership
•
Replacement of motors, engines, mechanisms, structural components, electrical components,
hydraulic components, safety devices and corresponding components
•
Signiicant faults and relative repairs
•
Regular inspections
OBliGATOrY
if there are not enough sheets in the logbook, add other sheets as necessary,
by photocopying them or preparing them in the same way as the ones already
present.
The user should indicate the type of platform, the factory serial number and
the year of construction on the additional sheets so that they can become an
integral part of this logbook.
