155
CHAPTER 3
INTRODUCTION TO CLI
3.9.39.15 (config-if)# qos egress tag-remark
Syntax:
(config-if)# qos egress tag-remark { pcp <pcp> dei <dei> | mapped }
Explanation:
Configure the appropriate egress remarking mode used by this port.
Parameters:
{ pcp <pcp> dei <dei> | mapped }: Specify a remarking mode.
pcp <pcp> dei <dei>:
Specify PCP and DEI value.
mapped:
Use the mapping of the classified QoS class values and DP levels to PCP/DEI values.
Negation
: (config-if)# no qos egress tag-remark
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
3.9.39.16 (config-if)# qos egress wrr
Syntax:
(config-if)# qos egress wrr <w0> <w1> <w2> <w3> <w4> <w5>
Explanation:
Assign egress weight for QoS queueing method. WRR stands for Weighted Round Robin and uses default
queue weights. The number of packets serviced during each visit to a queue depends on the percentages you
configure for the queues.
Parameters:
<w0: 1-100>: Specify weight for queue 0.
<w1: 1-100>: Specify weight for queue 1.
<w2: 1-100>: Specify weight for queue 2.
<w3: 1-100>: Specify weight for queue 3.
<w4: 1-100>: Specify weight for queue 4.
<w5: 1-100>: Specify weight for queue 5.
Negation
: (config-if)# no qos egress wrr
Show:
# show qos
# show qos [ { interface [ ( <port_type> [ <port> ] ) ] } | wred | { maps [ dscp-cos ] [ dscp-ingress-translation ]
[ dscp-classify ] [ cos-dscp ] [ dscp-egress-translation ] } | storm | { qce [ <qce> ] } ]
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
