109
CHAPTER 3
INTRODUCTION TO CLI
Negation:
(config-line)# no width
Show:
> show line [ alive ]
# show line [ alive ]
3.9.26 (config)# lldp
3.9.26.1 (config)# lldp holdtime
Syntax:
(config)# lldp holdtime <val>
Explanation:
This setting defines how long LLDP frames are considered valid and is used to compute the TTL. The
default is 4.
Parameters:
<val>: Specify the holdtime value. The allowed value is 2 to 10.
Example:
Set the holdtime to 5.
Negation:
(config)# no lldp holdtime
3.9.26.2 (config)# lldp reinit
Syntax:
(config)# lldp reinit <val>
Explanation:
Configure a delay between the shutdown frame and a new LLDP initialization.
Parameters:
<val>: Specify a value between 1 and 10 (seconds).
Example:
Set the LLDP re-initiation value to 3.
Negation:
(config)# no lldp reinit
3.9.26.3 (config)# lldp timer
Syntax:
(config)# lldp timer <val>
Explanation:
Configure the interval between LLDP frames are sent to its neighbors for updated discovery information.
The default is 30 seconds.
Parameters:
# config t
(config)# lldp reinit 3
# config t
(config)# lldp holdtime 5
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
