102
CHAPTER 3
INTRODUCTION TO CLI
3.9.24.2 (config-if)# lacp
Syntax:
(config-if)# lacp
Explanation:
Enable LACP on this interface.
Example:
Enable LACP on port 1.
Negation:
(config-if)# no lacp
Show:
# show lacp { internal | statistics | system-id | neighbour }
Clear:
# clear lacp statistics
3.9.24.3 (config-if)# lacp key
Syntax:
(config-if)# lacp key { <v_1_to_65535> | auto }
Explanation:
Configure a LACP key for this interface.
Parameters:
{ <v_1_to_65535> | auto }: Specify a LACP key for this interface. The “auto” setting sets the key as appropriate by
the physical link speed. If you want a user-defined key value, enter a value between 1 and 65535. Ports in an
aggregated link group must have the same LACP port Key. In order to allow a port to join an aggregated group,
the port Key must be set to the same value.
Negation:
(config-if)# no lacp key { <v_1_to_65535> | auto }
Show:
# show lacp { internal | statistics | system-id | neighbour }
3.9.24.4 (config-if)# lacp port-priority <v_1_to_65535>
Syntax:
(config-if)# lacp port-priority <v_1_to_65535>
Explanation:
Configure a LACP key for this interface.
Parameters:
<v_1_to_65535>}: Specify a LACP port priority for this interface. The lower number means greater priority. This
priority value controls which ports will be active and which ones will be in a backup role.
Negation:
(config-if)# no lacp port-priority <v_1_to_65535>
Show:
# show lacp { internal | statistics | system-id | neighbour }
# config t
(config)# interface GigabitEthernet 1/1
(config-if)# lacp
(config-if)#
Summary of Contents for MSW-4424C Series
Page 1: ...1 MSW 4424C MSW 4424CS L2 Gigabit Carrier Ethernet Switch ...
Page 382: ......
