46
CHAPTER 3
CLI CONFIGURATION
Parameters:
[interface (<port_type>[<v_port_type_list>])]: Specify the port type and port numbers that you want to reopen.
3.8.46 # show interface ( <port_type> [ <v_port_type_list> ] ) veriphy
Syntax:
# show interface ( <port_type> [ <v_port_type_list> ] ) veriphy
Explanation:
Issuing this command will run the VeriPHY™ Cable Diagnostics for 10/100 and 1G copper ports. This will
take approximately 5 seconds per port. If all ports are selected, this can take approximately 15 seconds. When
completed, the page refreshes automatically, and you can view the cable diagnostics results in the cable status table.
Note that VeriPHY is only accurate for cables of length 7 - 140 meters.
10 and 100 Mbps ports will be linked down while running VeriPHY. Therefore, running VeriPHY on a 10 or 100 Mbps
management port will cause the switch to stop responding until VeriPHY is complete.
Parameters:
( <port_type> [ <v_port_type_list> ] ): Specify the port type and port number that apply to this Veriphy
diagnostics test.
3.8.47 show commands
In Exec mode, “show” commands can be issued to display current status or settings of a certain command. They
will be introduced in Section 3.9 “Commands in Config Mode”.
3.9 Commands in Config Mode
3.9.1 (config)# aaa authentication login
Syntax:
(config)# aaa authentication login { console | telnet | ssh | http } { { local | radius | tacacs } [ { local | radius |
tacacs } [ { local | radius | tacacs } ] ] }
Explanation:
Configure the authentication method for the client.
Parameters:
{ console | telnet | ssh | http }: Specify one of the authentication clients.
{ { local | radius | tacacs } [ { local | radius | tacacs } [ { local | radius | tacacs } ] ] }: Specify one of the
authentication methods for the specified client. At least one method needs to be specified. Users can specify
three methods at most.
local:
Use the local user database on the switch for authentication.
radius:
Use remote RADIUS server(s) for authentication.
tacacs:
Use remote server(s) for authentication.
NOTE:
Methods that involve remote servers will time out if the remote servers are offline. In this case the next method
is tried. Each method is tried and continues until a method either approves or rejects a user. If a remote server is used
Summary of Contents for IFS-1604GSM Series
Page 385: ......
