Chapter 4. Web Configuration & Operation
257
CHAPTER 4
WEB OPERATION & CONFIGURATION
SIP Address:
Specify a source IP address.
SIP Mask:
Specify a source subnet mask.
DIP Filter:
Select “Any”, “Host”, or “Network” for destination IP filtering. If “Host” is selected, you need to indicate a
specific host IP address. If “Network” is selected, you need to indicate both network address and subnet mask.
DIP Address:
Specify a destination IP address.
DIP Mask:
Specify a destination subnet mask.
IPv6 Parameters
Next Header Filter:
Select next header filter option. Available options include ICMP, UDP, TCP, Other.
SIP Filter:
Select a source IP filter. “Any” denotes that any SIP filter is allowed. Select “Specific” to enter self-define SIP
filter.
Hop Limit:
Select “Any” to allow any values in this field. Select” “0” if IPv6 frames with a hop limit field greater than
zero must not be able to match this entry. “1” denotes that IPv6 frames with a hop limit field greater than zero must
be able to match this entry.
4.5.5.3.4 ACL Status
This page shows the ACL status by different ACL users. Each row describes the ACE that is defined. It is a conflict if a
specific ACE is not applied to the hardware due to hardware limitations. The maximum number of ACEs is 256 on each
switch.
User:
Display the ACL user.
Ingress Port:
Display the ingress port of the ACE. This field could be all ports, a specific port or a range of ports.
Frame Type:
Display the frame type of the ACE. Possible values are:
Any:
The ACE will match any frame type.
EType:
The ACE will match Ethernet Type frames. Note that an Ethernet Type based ACE will not get matched
ARP:
The ACE will match ARP/RARP frames.
IPv4:
The ACE will match all IPv4 frames.
IPv4/ICMP:
The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP:
The ACE will match IPv4 frames with UDP protocol.
Summary of Contents for IFS-1604GSM Series
Page 385: ......