195
CHAPTER 3
CLI CONFIGURATION
Show:
# show vlan ip-subnet [ id <subnet_id> ]
3.9.46.15 (config-if)# switchport vlan mac
Syntax:
(config-if)# switchport vlan mac <mac_addr> vlan <vid>
Explanation:
This command is to set up VLANs based on source MAC addresses. When ingress untagged frames are
received by a port, source MAC address is processed to decide which VLAN these untagged frames belong. When
source MAC addresses does not match the rules created, untagged frames are assigned to the receiving port’s native
VLAN ID (PVID).
Parameters:
<mac_addr>: Indicate the source MAC address. Please note that the source MAC address can only map to one
VLAN ID.
vlan <vid>: Map this MAC address to the associated VLAN ID.
Negation:
(config-if)# no switchport vlan mac <mac_addr> vlan <vid>
Show:
# show vlan mac [ address <mac_addr> ]
3.9.46.16 (config-if)# switchport vlan mapping
Syntax:
(config-if)# switchport vlan mapping <group>
Explanation:
Configure group VLAN mapping table for this specific interface.
Parameters:
<group: 1-20>: Indicate the Group ID that applies to this rule.
Negation:
(config-if)# no switchport vlan mapping
3.9.46.17 (config-if)# switchport vlan protocol group
Syntax:
(config-if)# switchport vlan protocol group <grp_id> vlan <vid>
Explanation:
Configure VLAN protocol group for this specific interface.
Parameters:
<grp_id: word 16>: Indicate the descriptive name for this entry. This field only allows 16 alphabet characters (a-z;
A-Z) or integers (0-9).
<vid>: Specify the VLAN ID that applies to this rule.
Negation:
(config-if)# no switchport vlan protocol group <grp_id> vlan <vid>
Summary of Contents for IFS-1604GSM Series
Page 385: ......
