180
CHAPTER 3
CLI CONFIGURATION
3.9.44.5 (config-stp-aggr)# spanning-tree edge
Syntax:
(config-stp-aggr)# spanning-tree edge
Explanation:
If an interface is attached to end nodes, you can set it to “Edge”.
Negation:
(config-stp-aggr)# no spanning-tree edge
Show:
# show spanning-tree
3.9.44.6 (config-stp-aggr)# spanning-tree link-type
Syntax:
(config-stp-aggr)# spanning-tree link-type { point-to-point | shared | auto }
Explanation:
Configure the link type attached to an interface.
Parameters:
{ point-to-point | shared | auto }: Select the link type attached to an interface.
point-to-point:
It is a point-to-point connection.
shared:
It is a shared medium connection
auto:
The switch automatically determines whether the interface is attached to a point-to-point link or
shared medium.
Negation:
(config-stp-aggr)# no spanning-tree link-type
Show:
# show spanning-tree
3.9.44.7 (config-stp-aggr)# spanning-tree mst <instance> cost
Syntax:
(config-stp-aggr)# spanning-tree mst <instance> cost { <cost> | auto }
Explanation:
Configure MSTI and its’ path cost value.
Parameters:
mst <instance: 0-15>: Specify MST instance number. Specify “0” to denote CIST. Specify “1-15” to denote MSTI 1-
15.
cost { <cost> | auto }: Specify a Path cost value that is used to determine the best path between devices. Valid
values are 1 to 200000000. If “auto” mode is specified, the system automatically detects the speed and duplex
mode to decide the path cost. Please note that path cost takes precedence over port priority.
Negation:
(config-stp-aggr)# no spanning-tree mst <instance> cost
Show:
# show spanning-tree
Summary of Contents for IFS-1604GSM Series
Page 385: ......
