CTC Union FMUX160, User Manual

Page: 42 / 56

Chapter 4. Web Based Operation (SNMP option required)
42
4.4 Provisioning via Web
When an active fiber link is established, both local and remote Fiber Multiplexers can be provisioned via simple web
interface.
4.4.1 Device Configuration
From the 'Device' tab, the status of SNMP, Power and alarms can be easily viewed. There are 5 items that can be
configured here.
1. Device Active ‐ If disabled, all traffic through this device is stopped, all LEDs will be extinguished, the Power LED will
blink intermittently every 3 seconds.
2. E1/T1 Mode ‐ Unless this is a BNC unit (E1 Only), the transmissions may be configured for either E1 or T1. If an RJ ‐ 45
model is configured for E1 75 Ohm, adapter cables may be used to convert the RJ ‐ 45 connectors to a pair of Female
BNC connectors.
3. Alarm Relay ‐ When enabled, this relay can be wired in either a normally open or normally closed circuit and
respond to alarm conditions.
4. Alarm Buzzer ‐ When enabled, an audible alarm is heard as long as an alarm condition exists.
5. Alarm Triggers ‐ When checked, the 'Power', 'Optical', 'LAN', and 'RDI' alarms will also generate SNMP traps by the
network agent.