Installation Instructions for FMC-10/100I
10/100BASE-T/TX to 100BASE-FX
In-band Managed Fiber Media Converters
Description
The FMC-10/100I is a media converter for 10Base-T or 100Base-TX, data transmission over optical
fiber media depending on your specific network needs. All media converters are available with either
multi-mode or single-mode optical transceivers and with connectors for SC, ST or FC. In single mode,
WDM (Wave Division Multiplexing with SC connector) is also available in 20, 40, 60, or 80Km reach,
which will provide the ability to transmit and receive data using only a single optical fiber. When the
FMC-10/100I is connected with the FRM220 rack, then it features with In band management, the
converter can be monitored, configured and controlled the activity of each port for both local or
remote sides. For the UTP side, auto-negotiation is default. You may set data rate to 10Mbps or
100Mbps and duplex mode to full or half only. The Fiber Transceiver Converters give you the freedom
to extend your 10/100Mbps cabling distance by allowing connectivity up to 120 kilometers. Six LED
indicators signal the power status of the converter, UTP port speed, duplex status and Link/Act and
FX port Link/Act and FEF (Far End Fault).
V.: 1.1
Specifications
Standard
IEEE802.3 10BASE-T, IEEE802.3u 100BASE-TX, l00BASE-FX (Fast Fiber, 100Mbps)
Supports Full Duplex Ethernet mode (200Mbps),
FMC-10/100I family supports transmission of Ethernet packet up to 2046Bytes in size.
10/100BASE-TX RJ-45 Connectors
One RJ-45 connector is provided for connection to MDI-X (To PC) or MDI (To HUB) equipment.
Auto MDI-X allows all UTP connections to be made using only a common straight-through UTP cable.
MDI-X type
MDI type
RJ-45 Pin
1
2
3
6
Rx+
Rx -
Tx+
Tx -
Tx+
Rx+
100BASE-TX UTP Cable
Cable type: 100Base-Tx; Category 5 or better
Maximum cable distance: 100 meters (328 feet)
Fiber Optic Connectors
For FMC-10/100I: Two connectors are provided for fiber optic cable connection.
One is for transmission and the other is for reception of optical data
For FMC-10/100I WDM: One connector is provided for fiber optic cable connection.
For both transmission and reception of optical data.
*Please note that transceiver type A must connect to transceiver type B for proper fiber linking.
Environment
Temperature : 0
o
C –50
o
C
Humidity: 5-95% non condensing
Dimension
73.4mm x 108mm x 23mm
( W x D x H )
Power
AC a12V / 400mA
Tx -
Rx -
Fiber
Connections
Ethernet
Connections
DC Jack
LEDs
Features
*Auto Negotiation or Manual mode in TP port
*Link fault pass through (LFP) function
*Forward 2046 bytes packets in switch mode
*Forward 9K jumbo packets in convert mode
*Compatible with FRM220 Chassis In Band Management
*Bandwidth control (32K or 512Kbps x N)
*Support operation mode : Convert and Switch mode
*Support local or remote Monitor
(Link/Speed/Duplex/Power)
*Support local or remote Configure
(Speed/Duplex/port disable/Operating mode
*Support remote CPE power fail detect
*Provide Auto Laser Shutdown (ALS) function
*Support On-Line F/W upgrade (remote)
F
E
F
F
E
F
FULL FEF
