CTC Parker Automation
A3-06021-100
P C 9 / P 9 C D - R O M R e p l a c e m e n t
Introduction
These instructions explain how to replace a CD-ROM drive in the PC9
Industrial PC or P9 PowerStation. They include steps for disassembling
the unit, removing a previously installed drive, installing a new drive, and
reassembling the unit.
Warning
For safety reasons, the unit should be opened only by qualified
service personnel.
Warning
Be sure to observe electrostatic discharge (ESD) precautions
while working inside the unit.
To complete this procedure, you will need the following items:
•
CD-ROM Replacement Kit for PC9/P9 (CDR-9000)
•
Phillips-head screwdriver
Disassembling the Unit
To disassemble the unit, follow these steps:
1. Turn off the unit.
2. Disconnect the unit from the power source.
3. Disconnect all cables attached to the unit.
4. Remove the two screws securing the backshell to the faceplate as-
sembly, as shown below.
screws
these
Remove