12
Subject to technical changes
© CTA 10/2016 www.cta.ch
Active priority control
NOTE
Heating, DHW and cooling modes can never be carried out at the same time. This symbol indi-
cates which mode is currently being operated.
- Heating symbol
→
Heating mode is active, water tap symbol
→
DHW mode is active or
cooling symbol
→
cooling mode is active
The current regulating temperature is displayed for this purpose
- Nominal: Current nominal temperature required from all active consumers
Compressor status
- The compressor symbol rotates
→
The heat pump is in operation
- The compressor symbol is stationary
→
The heat pump is not in operation
NOTE
More displays for the current state are represented in the operating level „Information“.
4: External release
Draw wish / forced
appears in case of increased heat demand. (Operation with SG Ready).
External blocked
appears when, e.g., EW block is active. The compressor symbol is crossed-out
.
3.1.2 General navigation
3
7
6
2
4
1
5
1: Operating level
2: Current screen / number of screens on this level
3: Number of parameter selected
4: Umbrella term of the parameter of this mask
5: Parameter selection
6: Parameter designation (parameter selected, - parameter
that can be selected)
7: Parameter value
3.1.3 Change parameters
1
2
3
1
In order to change a parameter or the operating mode, this (these) must be selected on the respective mask
using the arrow keys
. Press Enter
to select the parameter. This is then highlighted black.
2
When pressing the arrow keys
you can now change the functions or values. When pressing the Enter
key
, changes are confirmed and the parameter is no longer highlighted black.
3
Several parameters such as, e.g., the time are changed in two steps. When pressing the Enter key
, in
this case you access the hours and by pressing again, you access the minutes. Pressing Enter
for a third time
completes the changes.
Basic information on operation
