Installation Guide
Wiegand Readers
CSI Readers
35
Refer to the I/NET 2000 System Operator Guide or Technical Reference Guide for more
information concerning I/NET 2000.
Dorado 780 PIN Pad Operation
The Dorado 780 reader makes use of the following three LEDs:
✦
Red LED – Labeled “Swipe Card”
✦
Yellow LED – Labeled “Enter PIN”
✦
Green LED – Labeled “Open Door”
The control for the LEDs is provided through two lines labeled CONTROL A and
CONTROL B. Refer to the installation instructions above for the connection locations
of these lines. TCON116,
DPU-7910A Installation Guide
, and TCON117,
DPU-7920
Installation Guide
, describe how to configure the DPU to support three-color LED oper-
ation.
If the door is in SECURE or PIN mode, the red LED will be on. During this time, the user
may pass their card through the swipe card reader. A bad card read is indicated when the
red LED flashes on and off for approximately 2 seconds. In this case, the user should once
again pass their card through the swipe card reader. After a valid card read, if the door is
in PIN mode, the red LED will turn off and the yellow LED will turn on. During this
time, the user must enter a 5-digit personal identification number (PIN). As each digit
is entered, it is sent immediately to the DPU. If an incorrect digit is pressed, the user may
press the asterisk (*) key to clear the memory and reenter the entire PIN. The * key can
be used twice during the PIN entry sequence (pressing the * key a third time will termi-
nate the entry sequence and require the user to start over with a valid card read). Pressing
the fifth digit or the pound (#) key ends the PIN entry sequence. If less than 5 digits have
been entered when the user presses the # key, then all digits that have not been entered
will be interpreted as zero(s). If the user does not press the fifth digit or the # key within
15 seconds of the card read, then the reader will time-out and the card will have to be
read again to restart the sequence.
The Dorado 780 reader also supports the silent duress annunciation feature of I/NET
version 4.3x and later. Refer to
“Silent Duress Annunciation” on page 32
for more infor-
mation about this feature.
Summary of Contents for CARDPIN1
Page 5: ...Installation Guide CSI Readers v Specifications 45 Index 49...
Page 58: ......
Page 59: ......
