Safety instruction
LD 450 V1.00
Seite
3
von
23
2
Safety instructions
About this document
•
Read this documentation carefully and familiarize yourself with the product
before using it. Pay particular attention to the safety and warning instructions to
prevent injury and product damage.
•
Keep this documentation handy for future reference.
•
Share this documentation with future users of the product.
2.1
General safety instruction
•
The product is to be used only in accordance with the intended purpose and
within the parameters specified in the technical data. Do not use force for
operation.
•
Never measure with the device at or near live/energized parts!
•
During leak detection on electrical systems, please maintain a sufficient safety
distance to avoid dangerous electric shocks!
•
Avoid any direct contact with hot and/or rotating parts.
•
Always switch on the device before putting on the headphones! At high signal
levels (bar graph headphones in the red area), the volume can be correspondingly
large. The sensitivity setting can be used to reduce the volume.
•
Observe the prescribed storage and operating temperatures.
•
In case of improper handling or violence, the warranty claims are lost.
•
Interventions on the device of any kind, unless they correspond to the intended
and described procedures, lead to the expiration of warranty and to the
disclaimer.
•
The device is intended solely for the described purpose.
2.2
Using of class 2 laser
•
Never point the laser directly towards persons!
•
Absolutely avoid a direct irradiation of the eyes of humans and animals!
•
If a person‘s eyes are exposed to class 2 laser radiation, they should shut their
eyes and immediately move away from the beam
•
Do not stare into the beam
•
Laser module: corresponds to DIN EN 60825-1: 2014 Class 2 (<1mW / 635nm)
•
Laser output point trumpet and parabolic mirror:
Laseraustrittstelle
Laser output point
