Crystal Vision
Hardware installation
2 Hardware installation
All of the links and potentiometers on the card are factory set and should
NOT
be adjusted.
SYNNER-VF cards are intended for use
only
in the Crystal Vision ‘Vision’ frame range and
not in older style frames such as ‘Indigo’.
The card should be inserted and removed from the Vision Frame by gently pushing or pulling
the metal ring at the bottom of the card, being careful to ensure the card is inside the guide
rails. Do not force the card if resistance is met as the card may not be correctly aligned with
the rear connectors. The white tab at the top of the board is a label only and should not be
pulled.
Ensure that the Vision frame has the correct rear module fitted. Only the VR02, VR12 and
VR13 rear modules offer the correct input/output functionality for this card.
2.1 Piggyback boards
The SYNNER-VF board has two positions where one of three types of piggy-backed I/O
module can be plugged to enable analogue or digital input and output.
The three types of piggybacks are 3G-AIP2, 3G-AOP2 and DIOP4.
SYNNER-VF card with two piggyback boards fitted
SYNNER-VF User Manual R1.1
8
03 January 2017
