Crystal Vision
Installing Crystal Vision modules
4 Installing Crystal Vision modules
The Indigo desk top boxes each have two slots for Crystal Vision video or audio
cards. Signal connections are made through single or double rear modules.
An optional rack mount kit IDT-RK allows the 1U Indigo desk top box to be mounted
into a 19" rack mount frame.
The inside of the frame can be accessed to change the modules by unscrewing the
two black knobs, one on each side of the front panel.
Module positions
Module positions are numbered 1 to 2 as shown below:
The Indigo DT box showing slot numbers
Before fitting or removing signal modules the retaining brackets may need to be
removed. Retaining brackets prevent modules from being inadvertently disconnected
or from coming out during transit. They may also prove useful in OB vehicles when
travelling over rough ground.
Note:
The internal PSU is fitted inside the right hand compartment.
Inserting modules
To insert a module proceed as follows:
•
Remove the two screws holding the bracket and keep both the screws
and bracket in a safe place
•
Insert the module into the appropriate guides and push it fully home
•
Refit the retaining bracket if required
The Indigo DT box with two modules fitted in slots 1 and 2
Removing modules
To remove signal modules simply pull on the handle and withdraw them from the
frame, with the retaining bracket removed.
All Crystal Vision cards can be inserted and removed whilst the frame is powered
without damage.
Indigo DT User Manual R1.8
26
05 July 2018
