Crystal Vision
Control
Windows 7 Advanced LAN settings
Alternatively, the LAN controller sub-mask can be extended to allow control of frames of similar
IP address. For instance if a frame is to be finally configured as 10.0.1.0 then a sub-mask of
255.255.0.0 would allow control of the frame in its default and final configuration.
Setting Default IP address
For Indigo 1AE users, the frame’s current IP address is displayed on the active front panel but
should a frame’s IP address be unknown, it is possible to temporarily set the frame to its default
IP address (10.0.0.201) by moving configuration switch S2 on the upper PCB to the left
.
The
front panel CPU must now be reset in order for changes in the switch settings to be
implemented. This can be achieved by briefly interrupting the power to the frame or removing
the ribbon-cable connection to the front panel. Care must be taken not to bend any pins in the
cable connect as attempting to re-straighten any bent pins will likely result in their fracture.
The frame will enter ‘Recovery Mode’ on reset or power up where it can be accessed by its
default IP address 10.0.0.201.The network address can now be permanently changed with a
browser.
Indigo 1 User Manual R1.14
26
27 February 2020
