019 0021
Door Speakers
8
1.
Starting at the front edge, pry out
screw
cover
behind door release to release one (1)
clip and remove screw cover. Remove one
(1) exposed 7mm screw (Figure 1).
2.
Starting at the front edge, pry up
power
options switch panel
to release five (5) clips.
Disconnect wiring harness and remove panel
(Figure
2).
3.
Remove one (1) 10mm screw exposed by
removal of power options switch panel
(Figure
3).
4.
Remove two (2) 7mm screws along bottom
edge of door panel (Figure 4).
Continued on the next page.
Copyright 2018 Crutchfield Corporation
1-800-955-9094
TECHNICAL SUPPORT
NOTES:
Please read first
•
Instructions show factory size speakers or speakers
with adaptor brackets only. Cutting or fabrication (not
shown) will be required for other speaker sizes.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
Screw Cover
Screw Cover
Power Options Switch Panel
Power Options Switch Panel
No speaker wiring adaptor is available at this time from
Crutchfield for the midrange location. It will be necessary to
splice wires in order to install an aftermarket speaker.
IMPORTANT
!