Rugged, Reliable, Mobile, Secure
TM
1-800-260-9800
www.CRU-DataPort.com
Package Contents
1 - DataPort LP SAS/SATA Carrier
1 - DataPort LP SAS/SATA Frame
4 - 6 x 32 x 3/8” flat-head screws for hard drive mounting
4 - M3 x 10mm Phillips pan-head screws for frame mounting
Installation Instructions
To install the DataPort LP, remove the carrier from the frame. To
remove the carrier, press the release button on the left corner
of the carrier. This will release the ejection lever to remove the
carrier (see figure 1). Extend the ejection lever fully to release the
carrier. Use the lever to pull the carrier out of the frame.
Install the Frame Into the Enclosure
1. Slide the frame into the enclosure and, using the screw holes
provided, secure the frame into the enclosure. For installations
requiring mounting rails, attach the mounting rails and then
slide the frame into the enclosure.
2. Connect the data cable and the power cable to the back of
the frame. For SATA support connect the HBA to JP4. For SAS
support use JP5 or JP4 (see figure #2). For dual host support
each data connector must be connected to a different host.
Install the Hard Disk Drive Into the Carrier
1. Slide the SAS or SATA hard drive into the carrier and secure it
with the provided screws.
2. Make sure the lever is fully extended before inserting the
carrier into the frame. Insert the carrier and then close the
lever by pushing it back in to complete the insertion and secure
the carrier. Power up the enclosure; the drive should spin up
and be operational. The green LED indicates that the drive is
powered up and the amber LED indicates drive activity.
Figure 1: Front View
DataPort LP SAS/SATA Install Guide
The DataPort LP is designed to mount via top, bottom, or
side mounts. This allows the maximum number of options
to mount the DataPort LP into any enclosure.
release
button
