RFBA & RFBA Plus User Manual
Crown Broadcast
Page 20
IP:
This displays the current IP address of the RFBA. The user can modify this address by using
the buttons to navigate and change. Once the user input is complete, push the enter button to
have the RFBA accept your request to change IP address. This change will not take effect until the
RFBA is rebooted either through the soft reset command or cycling power.
SUBNET:
This displays the current subnet address of the RFBA. The user can modify this address
by using the buttons to navigate and change. Once the user input is complete, push the enter
button to have the RFBA accept your request to change the subnet address. This change will not
take effect until the RFBA is rebooted either through the soft reset command or cycling power.
GATEWAY:
This displays the current gateway address of the RFBA. The user can modify this
address by using the buttons to navigate and change. Once the user input is complete, push the
enter button to have the RFBA accept your request to change the subnet address. This change will
not take effect until the RFBA is rebooted either through the soft reset command or cycling power.
MAC:
This displays the MAC address of the RFBA. The user cannot modify this value.
It is used for display purposes only.
System Setup Menu
The RFBA system menu is designed to show the general features of this product. A description of each
of the monitor features is detailed below:
S Y S T E M
M O D E L
N O :
R F B A - 1 M A
→ S E R I A L
N O :
0 0 4 5 1
F I R M W A R E
R E V :
1 . 0 0
R E G I O N :
U S A
S O F T
R E S E T :
C A U T I O N ! ! !
R E S T O R E
D E F A U L T S :
S T A R T
R E L A Y :
0 : 3 : 7
S C R E E N T I M E O U T :
1
M I N
S C R E E N A U T O L O C K :
5
M I N
M O D A N K E Y : I N S T A L L E D
Figure 13 - System Menu
Model Number:
This is the Model number of your unit. This value can’t be changed by the user.
Serial Number:
This is the Serial number of your unit. This value can’t be changed by the user.
Firmware Revision:
This is the Product firmware revision. This value can’t be changed by
the user.
Region:
This is the region setting of the RFBA. The RFBA can be set to USA, Europe or
Japan bands. Changing the region setting will change the band frequencies, channel spacing, and