Crown PCC-170SW Datasheet Download Page 1

  POLAR
PATTERN

PHASE COHERENT 
CARDIOID

®

 MICROPHONE

T

he Crown

®

  PCC

®

-170SW is a surface-

 mounted supercardioid microphone of 
 professional quality. This handsomely 

styled unit is appropriate for use on the most 
elegant boardroom table or lectern. Other ap-
plications include churches, courtrooms and 
council chambers.

The PCC-170SW has a silent-operating mem-
brane switch which is normally off. The switch 
can be confi gured for touch on/off, momentary 
on or momentary off operation. This confi gura-
tion is set by a bottom-mounted DIP switch. A 
high-intensity LED lights when the unit is on. 
The PCC-170SW is intended for multiple-
microphone use on a conference table where 
each person wants control of his or her micro-
phone.
The microphone attenuates 70 dB when the 
switch is in the off position. Since the micro-
phone capsule is placed on a boundary or 
surface, direct and refl ected sounds arrive at 
the diaphragm in-phase, resulting in a wide, 
smooth frequency response free of phase inter-
ference. Clarity and reach are also enhanced.
Self-contained electronics eliminate the need for 
an in-line preamp. Powered by 12-48V phantom 
power, the PCC-170SW has a low-impedance 
balanced output which permits long cable runs 
without hum pickup or high-frequency loss. 
Although the standard connector option is a 
Switchcraft TB3M, the microphone can be spe-
cial-ordered with a ¼-inch (6.35-mm) stereo 
phone plug on the bottom of the base plate as 
the PCC-170SWSPP.
RFI suppression is included. Self-noise is low 
and sensitivity is very high. A bass-tilt switch 
allows the user to tailor the low-end response 
for particular applications.

Membrane Switch

The PCC-170SW membrane switch can be con-
fi gured to work three ways:
1. 

Touch on/off.

 Touch the switch to turn on 

the mic; touch it again to turn off the mic.
2. 

Momentary on.

 Touch and hold the switch to 

turn on the mic momentarily. Release the switch 
to turn the mic back off.
3. 

Momentary off.

 Touch and hold the switch 

to turn off the mic momentarily. Release the 
switch to turn the mic back on. This option can 
serve as a cough or privacy button.
After choosing the option you prefer, set the DIP 
switches according to the label on the bottom of 
the microphone (see Fig. 5). The LED in the mi-
crophone housing will light when the mic is on. 

Specifi cations

Type: 

 Phase Coherent Cardioid

®

.

Element:  

Electret condenser.

Frequency response (typical): 

 50 Hz to 20,000 Hz at 

30 degrees incidence to surface (see Fig. 1).

Polar pattern:

  Half-supercardioid (supercardioid in 

the hemisphere above the primary boundary).  See 
Figs. 2 and 3.

Impedance:

  150 ohms, balanced (recommended load 

impedance 1000 ohms or greater).

Open circuit sensitivity (typical):

  22 mV/Pa* (–33 dB 

re 1 volt/Pa).

Power sensitivity:  

–30.5 dB re 1 mW/Pa*.  EIA rating 

–125 dBm.

Equivalent noise level (self-noise): 

 22 dB SPL typi-

cal (0 dB = 0.0002 dyne/cm

2

), A-weighted.

S/N ratio:

  72 dB at 94 dB SPL.

Maximum SPL:

  120 dB SPL produces 3% THD.

Off Attenuation: 

 70 dB at 1 kHz.

Turn-on time: 

250 msec.

Turn-off time: 

125 msec.

Polarity:  

Positive pressure on the diaphragm 

produces positive voltage on pin 2 with respect to 
pin 3

.

Operating voltage:  

Phantom power, 12 to 48 volts DC 

on pins 2 and 3 with respect to pin 1.

Current drain:  

6 mA nominal.

Connector:

  Switchcraft TB3M in model PCC-170SW.  

Bottom-mounted ¼-inch (6.35-mm) stereo phone 
plug in model PCC-170SWSPP. See Fig. 7.

Cable:

  15-foot, black, two-conductor shielded cable 

with Switchcraft TA3F and A3M connectors.

 

No 

cable supplied with SPP option.

Materials:  

High-impact molded plastic and steel 

mesh grille.

Finish:

  Black. 

Net weight:

  6 oz. (170 g).

Dimensions:

  See Figs. 4 and 7.

Optional accessories:

   Crown PH-1A  phantom 

power  supply (single channel, battery or AC 
adapter powered).

*1 pascal = 10 dynes/cm

2

 = 10 microbars = 94 dB SPL.

Features

Perfect for multimiking applications in telecon-
ferencing, distance learning, and boardrooms

Phase Coherent Cardioid

®

 design prevents 

coloration from surface sound refl ections

 

Half-supercardioid polar pattern reduces 
ambient noise and room reverberation

Programmable on/off membrane switch

   Balanced XLR output

PCC

®

-170SW

Fig. 1

Frequency in Hz

Frequency Response

Fig. 2

Horizontal-Plane Polar Response

Fig. 3

Vertical-Plane Polar Response

Reviews: