Crow SH-MAG-SHOCK-8F, Instruction Manual

Page: 1 / 3

SH-MAG-SHOCK-8F/9F
TWO WAY WIRELESS
MAGNETIC DOOR/WINDOW CONTACT
& SHOCK DETECTOR
PRODUCT FEATURES DETECTOR OPENING CIRCUIT LAYOUT
The SH-MAG provide perimeter protection for premises with
early warning upon attempted intrusion.
SH-MAG & SHOCK device analyzes shocks while ignoring
background vibrations. It can be configured Over-The-Air and
feature a 5 year battery life.
• Freewave2™ Two Way ISM
• GFSK with 5 frequencies & LBT
• Immunity to attenuation feature
•
Powered by 1 Lithium batteries 3.0V Size CR123
•
Contact Open/Close transmission
• Shock detection transmission
• Tamper Open/Close transmission
• Battery life up to 5 years
•
Operating Frequencies: 868MHz or 916MHz
• Event Transmission:
Alarm
Tamper Open/Close
Supervision
Battery status
• Bi-Color LED indications
• Up to 500m transmission range in open space
• Remotely configurable
Figure 1
Pull out the detector cover
Figure 2
Remove the batteries cover
INSTRUCTION MANUAL
P/N 7101689_C
BATTERY INSERTION DETECTOR MOUNTING LEARNING PROCESS
Figure 3
Batteries can be replaced by the user
Battery type: Lithium. 3V Type: CR123A Size: 2/3AA
Figure 4
Place the Magnet unit near this marking
Figure 5
Basic installation at 10mm between FW2-Mag and Magnet Unit.
Configurations Axis
Removal Distance
(mm)
Approach Distance
(mm)
Wood
X 15 12
Y 20 17
Z 35 260
Iron
X 10 5
Y 17 14
Z 32 28
For pairing process, please refer to your control panel
instructions.
To pair your device with Shepherd
™
panel, please proceed
as follows:
1. Enter in installing mode via the "Installer Webpage"
2. Go to "Zones" and select the zone # you want to learn
1. Add Zone -(Reminder: insert Link Type “
ISM
” , device’s
ID , Device Type “ Magnetic & vibration sensor ”.)
2. Set the detector configuration: supervision time, VIB
sensitivity, and save configuration.
3. Place a battery as instructed in Figure 3 and wait until
the Red / Green LED stops blinking.
4. The device should register to the Control Panel.
5. When registration process is successfully completed, the
Green LED will constantly light ON for 3 seconds and
then turn OFF.
6. If Green LED continues flashing more than 5 minutes
and stopped, please check MAG-SHOCK settings
details, remove battery and repeat steps 3,4,5.
7. If Led flashes green constantly , please check if device’s
ID is correct or missing.