BTW0201C
BFW0301C
BATH WASTES
INSTALLATION INSTRUCTIONS
25mm
‘O’ ring
25mm
‘O’ ring
25mm
‘O’ ring
Push the rubber seal onto the housing, screw in the bolt and hold
the unit in position from the outside of the bath. From the inside
of the bath place the foam and face plate over the bath hole and
screw on the nut, finally screw on the cover.
Prepare the hose by sliding on the retaining nut, clear washer,
rubber washer, finally push the ‘O’ ring into position 25mm from
the end (see detail). Push the hose assembly up into the housing
and hand tighten the nut.
FOAM WASHER
FACE PLATE
COVER
NUT
BOLT
BATH
RUBBER SEAL
HOUSING
‘O’ RING
RUBBER WASHER
WASHER
RETAINING NUT
HOSE
‘O’ RING
RUBBER WASHER
WASHER
RETAINING NUT
HOSE
PLUG
BOLT
PLUG HOLE
SEAL
BATH
From below push the rubber seal into the hole in the bath
(see detail), then push on the housing. From inside the bath place
the plug hole in position on the seal, screw in the bolt and tighten
(use the small bolt for bath thicknesses up to 9mm and the
large bolt for thicknesses from 9mm to 35mm)
, finally screw in
the plug.
Prepare the hose by sliding on the retaining nut, clear washer,
rubber washer. Finally push the ‘O’ ring into position 25mm from
the end (see detail above). Push the hose assembly into the
housing and hand tighten the nut.
HOUSING
SEAL
Inside of bath
Prepare the assembly by pushing the ‘O’ ring onto the nut. Push
the rubber seal onto the housing, and hold the unit in position
from the outside of the bath. From the inside of the bath place
the base ring over the bath hole,
if the hole is to small, snap off
one of the lugs with a pair of long nose pliers
. Slide the insert
and body into the base ring and screw on the nut, finally screw on
the cover.
Push the hose onto the housing making sure that the 2 x ‘O’ rings
are in position within the hose.
Finally connect up the inlet which can be positioned either side
of the housing. An extra inlet elbow is supplied were dual feed
supply is required, remove the blanking socket as required.
BASE RING
BODY
COVER
NUT
‘O’ RING
BATH
RUBBER SEAL
‘O’ RINGS x 2
HOSE
‘O’ RING
RUBBER WASHER
WASHER
RETAINING NUT
HOSE
PLUG
BOLT
PLUG HOLE
SEAL
BATH
From below push the rubber seal into the hole in the bath
(see detail), then push on the housing. From inside the bath place
the plug hole in position on the seal, screw in the bolt and tighten
(use the small bolt for bath thicknesses up to 9mm and the
large bolt for thicknesses from 9mm to 35mm)
, finally screw in
the plug.
Prepare the hose by sliding on the retaining nut, clear washer,
rubber washer. Finally push the ‘O’ ring into position 25mm from
the end (see detail above). Push the hose assembly into the
housing and hand tighten the nut.
HOUSING
SEAL
Inside of bath
INSERT
INLET
BLANKING SOCKET
LUGS
HOUSING
Crosswater Bath Wastes.indd 1
21/8/07 15:08:50